UPS / Rackmount with RS232
MB1000 prevents critical equipment from losing setup configuration, stored data and hard-disk crashes. Shuts off projection equipment via IR control to allow the projector bulbs to go through a proper cool-down cycle before shutting off.
Outlet Bank 1 and 2 Indicator
Illuminated blue when outlet bank 1 and 2 are switched on.
Line Fault Indicator
This LED will illuminate in red to warn the user that a wiring problem such as a bad/missing ground or reversed wiring exists within the AC receptacle. If illuminated, disconnect all equipment and contact an electrician to insure outlet is properly wired.
USB to Computer
Outlet Bank 1 - Critical Load Outlets
Four battery powered, surge protected and AVR outlets for critical-load equipment insures temporary uninterrupted operation of connected equipment during a power failure.
IR Control Section
Indicator LED’s – Indicates status IR Output Jacks – Standard 1/8” (3.5mm) mono jack for connection to an IR flasher (IR flashers not included).
RS-232 Serial Communication Port
The serial port allows connection and communication between the UPS and an automation or computer system. This allows the installer to program a number of variables including the Critical Load Battery Threshold. See the software documentation for more information.